Skip Navigation
InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)CO
Posts
1
Comments
483
Joined
2 yr. ago
  • Seems like 60k miles for brake fluid replacement and 80k miles for low conductivity coolant replacement. Then also replace the normal coolant at 120k miles. This is for an Ioniq5.

    I feel like most electric cars don’t need to use brakes going downhill. The regen is heavy enough to maintain a reasonable speed.

  • Note that most residential ranges will not get hot enough to really stir fry. Even the best gas ranges will only go up to 25k BTU. In comparison, commercial wok ranges are more than 100k BTU.

    You could get a propane cooker but that’s not really practical for everyone.

    What ends up happening is you’re steam frying the food. Which is fine, you just won’t get the same texture as what a restaurant can produce.

  • Highball boulders are pretty unsafe if you fall near the top. This is why climbers will top rope to figure out all the moves first. This might be true of short outdoor boulders as well just to save effort.

    Then there are multi story bouldering walls where you fall onto a ramp. This type of wall will be taller than some rope walls.

  • Is this a UK thing? Rock climbing here in the US refers to all of it. And usually a gym with rope climbing will usually have a bouldering area. I don’t think I’ve been to a rope gym that didn’t have bouldering… hmmm maybe one small gym in Taiwan, but everywhere else either only had bouldering or had both.

    And then where do you draw the line with highballs and non-rope soloing?

  • Note that it will warp further when you get it home since Home Depot wood is unlikely to be fully dried and the environment in your home will be different as well.

    You’ll need to wait a couple of weeks to see what shape the wood settles into. If you try to build something now it might end up warping after construction.

    Even if you’re working with S4S lumber you still need to let it acclimate and then finish milling it if you really need very square pieces.

  • nocontextpics @feddit.org
    CookieOfFortune @lemmy.world

    PIC