I see a lot of people responded with a true clean slate, but really, a fork is a clean slate.
It's not like Graphene, or Lineage, or any others would stop working. More maintainers would be needed for security issues, but way less than to get (non-Android) Linux phones up to speed.
Many graphene users, myself included, use all FOSS software from outside Google's store.
It is almost always better to give money to your local food bank than to someone on the side of the road.
They buy in bulk, making the money go farther. Also, while casualties from panhandling are low, motor vehicle accidents are still common enough.
And yes, some people can't make it to the food bank, but that's a rarity. It's done because they can get more that way than at a food bank. Unfortunately food banks can't do the same (legal reasons).
It's a compressor, which is probably the problem. I'm using a DH11 on ESPHome, so am pretty confident of the accuracy, it's down in the bottom center of the cabinet. (I designed these https://nowsci.com/only-sensor)
I do. Especially when I was young. This was 2002, so it's probably the same store he went to all the time to browse. (Assuming this is real, of course).
Assuming I can get it working, not really. Your described method would be good for occasional prints, but terrible for higher volumes. Keeping an area at a target humidity (especially a small one) is much more efficient than a constantly running device.
I wonder if post-refund if a class-action lawsuit gets opened. While lawyers would take a huge cut, at least some would make it to the population.